| |
|
High Venality on heavy plate bending operation |
| |
|
Reduced overall dimension and easiness of transpiration for medium and big machines |
| |
|
Having the two bottom rolls horizontally moving means also a lower working height which requires a smaller foundation |
| |
|
pit and less anchoring load (in the smallest models you don’t need foundation ). |
| |
|
During production (pre –bending and bending phases), the plate keeps always its horizontal position. |
|
| |
|
The 3R UHS machine and full file the best pre – bending on every required diameter. The possibility to reduce centre-distance |
| |
|
between lower rolls realizes. A better pre bending during bending of tubes with small diameter and thickness. |
| |
|
Another important feature of the 3R UHS machine in the operating system of the top forming roll. Infact, the top forming |
| |
|
roll can be used as a traditional press brake allowing perfect re-rolling and calibration operation of the produced tubes. |
| |
|
In the same way it is also possible to obtain cones with heavy thickness by bending in several strokes the plates. |
| |
|
With some 3 and 4 rolls pyramidal machines it is necessary to tilt the top roll to allow the produced tube removel on the 3R UHS |
| |
|
machine in the no necessary and therefore it is much more easy to remove the tube. |
| |
|
Large working stroke allows to get best bending result. |
| |
STANDARD EQUIPMENTS |
|
| |
|
Digital Read – Outs |
| |
|
Interchangeable top roll for smaller diameter bending |
| |
|
Ground and polished rolls |
